As a new era of space exploration and development unfolds — one with far more private-sector investment and leadership — the potential for rapid growth is promising. National security, deep […]
Arrays of superconducting wires have been used to detect beams of high-energy charged particles. Much thinner wires are already used to detect single photons, but this latest incarnation uses thicker wires that can absorb the large amounts of energy carried by fast-moving protons, electrons, and pions. The new detector was created by an international team led by Cristián Peña at Fermilab.
In a single-photon detector, an array of superconducting nanowires is operated below the critical temperature for superconductivity – with current flowing freely through the nanowires. When a nanowire absorbs a photon it creates a hotspot that temporarily destroys superconductivity and boosts the electrical resistance. This creates a voltage spike across the nanowire, allowing the location and time of the photon detection to be determined very precisely.
“These detectors have emerged as the most advanced time-resolved single-photon sensors in a wide range of wavelengths,” Peña explains. “Applications of these photon detectors include quantum networking and computing, space-to-ground communication, exoplanet exploration and fundamental probes for new physics such as dark matter.”
A similar hotspot is created when a superconducting wire is impacted by a high-energy charged particle. In principle, this could be used to create particle detectors that could be used in experiments at labs such as Fermilab and CERN.
New detection paradigm
“As with photons, the ability to detect charged particles with high spatial and temporal precision, beyond what traditional sensing technologies can offer, has the potential to propel the field of high-energy physics towards a new detection paradigm,” Peña explains.
However, the nanowire single-photon detector design is not appropriate for detecting charged particles. Unlike photons, charged particles do not deposit all of their energy at a single point in a wire. Instead, the energy can be spread out along a track, which becomes longer as particle energy increases. Also, at the relativistic energies reached at particle accelerators, the nanowires used in single-photon detectors are too thin to collect the energy required to trigger a particle detection.
To create their new particle detector, Peña’s team used the latest advances in superconductor fabrication. On a thin film of tungsten silicide, they deposited an 8×8, 2 mm2 array of micron-thick superconducting wires.
Tested at Fermilab
To test out their superconducting microwire single-photon detector (SMSPD), they used it to detect high-energy particle beams generated at the Fermilab Test Beam Facility. These included a 12 GeV beam of protons and 8 GeV beams of electrons and pions.
“Our study shows for the first time that SMSPDs are sensitive to protons, electrons, and pions,” Peña explains. “In fact, they behave very similarly when exposed to different particle types. We measured almost the same detection efficiency, as well as spatial and temporal properties.”
The team now aims to develop a deeper understanding of the physics that unfolds as a charged particle passes through a superconducting microwire. “That will allow us to begin optimizing and engineering the properties of the superconducting material and sensor geometry to boost the detection efficiency, the position and timing precision, as well as optimize for the operating temperature of the sensor,” Peña says. With further improvements SMSPDs to become an integral part of high-energy physics experiments – perhaps paving the way for a deeper understanding of fundamental physics.
There are two main approaches to what we consider neuromorphic computing. The first involves emulating biological neural processing systems through the physics of computation of computational substrates that have similar properties and constraints as real neural systems, with potential for denser structures and advantages in energy cost. The other simulates neural processing systems on scalable architectures that allow the simulation of large neural networks, with higher degree of abstraction, arbitrary precision, high resolution, and no constraints imposed by the physics of the computing medium.
Both may be required to advance the field, but is either approach ‘better’? Hosted by Neuromorphic Computing and Engineering, this webinar will see teams of leading experts in the field of neuromorphic computing argue the case for either approach, overseen by an impartial moderator.
Left to right: Elisa Donati, Jennifer Hasler, Catherine (Katie) Schuman, Emre Neftci, Giulia D’Angelo
Team emulation: Elisa Donati. Elisa’s research interests aim at designing neuromorphic circuits that are ideally suited for interfacing with the nervous system and show how they can be used to build closed-loop hybrid artificial and biological neural processing systems. She is also involved in the development of neuromorphic hardware and software systems able to mimic the functions of biological brains to apply for medical and robotics applications.
Jennifer Hasler received her BSE and MS degrees in electrical engineering from Arizona State University in August 1991. She received her PhD in computation and neural systems from California Institute of Technology in February 1997. Jennifer is a professor at the Georgia Institute of Technology in the School of Electrical and Computer Engineering; Atlanta is the coldest climate in which she has lived. Jennifer founded the Integrated Computational Electronics (ICE) laboratory at Georgia Tech, a laboratory affiliated with the Laboratories for Neural Engineering. She is a member of Tau Beta P, Eta Kappa Nu, and the IEEE.
Team simulation: Catherine (Katie) Schuman is an assistant professor in the Department of Electrical Engineering and Computer Science at the University of Tennessee (UT). She received her PhD in computer science from UT in 2015, where she completed her dissertation on the use of evolutionary algorithms to train spiking neural networks for neuromorphic systems. Katie previously served as a research scientist at Oak Ridge National Laboratory, where her research focused on algorithms and applications of neuromorphic systems. Katie co-leads the TENNLab Neuromorphic Computing Research Group at UT. She has written for more than 70 publications as well as seven patents in the field of neuromorphic computing. She received the Department of Energy Early Career Award in 2019. Katie is a senior member of the Association of Computing Machinery and the IEEE.
Emre Neftci received his MSc degree in physics from EPFL in Switzerland, and his PhD in 2010 at the Institute of Neuroinformatics at the University of Zurich and ETH Zurich. He is currently an institute director at the Jülich Research Centre and professor at RWTH Aachen. His current research explores the bridges between neuroscience and machine learning, with a focus on the theoretical and computational modelling of learning algorithms that are best suited to neuromorphic hardware and non-von Neumann computing architectures.
Discussion chair: Giulia D’Angelo is currently a Marie Skłodowska-Curie postdoctoral fellow at the Czech Technical University in Prague, where she focuses on neuromorphic algorithms for active vision. She obtained a bachelor’s degree in biomedical engineering from the University of Genoa and a master’s degree in neuroengineering with honours. During her master’s, she developed a neuromorphic system for the egocentric representation of peripersonal visual space at King’s College London. She earned her PhD in neuromorphic algorithms at the University of Manchester, receiving the President’s Doctoral Scholar Award, in collaboration with the Event-Driven Perception for Robotics Laboratory at the Italian Institute of Technology. There, she proposed a biologically plausible model for event-driven, saliency-based visual attention. She was recently awarded the Marie Skłodowska-Curie Fellowship to explore sensorimotor contingency theories in the context of neuromorphic active vision algorithms.
About this journal
Neuromorphic Computing and Engineering is a multidisciplinary, open access journal publishing cutting-edge research on the design, development and application of artificial neural networks and systems from both a hardware and computational perspective.
Editor-in-chief: Giacomo Indiveri, University of Zurich, Switzerland
In this episode of the Physics World Weekly podcast I look at what’s new in the world of physics with the help of my colleagues Margaret Harris and Matin Durrani.
Then, we run time in reverse and go back to the German island of Helgoland, where in 1925 Werner Heisenberg laid the foundations of modern quantum mechanics. The island will soon host an event celebrating the centenary and Physics World we be there.
The European Space Agency will request funding from member states for an Earth observation satellite system for security applications, blurring the line between its traditional civil focus and defense work.
When implanted medical devices like urinary stents and catheters get clogged with biofilms, the usual solution is to take them out and replace them with new ones. Now, however, researchers at the University of Bern and ETH Zurich, Switzerland have developed an alternative. By incorporating ultrasound-activated moving structures into their prototype “stent-on-a-chip” device, they showed it is possible to remove biofilms without removing the device itself. If translated into clinical practice, the technology could increase the safe lifespan of implants, saving money and avoiding operations that are uncomfortable and sometimes hazardous for patients.
Biofilms are communities of bacterial cells that adhere to natural surfaces in the body as well as artificial structures such as catheters, stents and other implants. Because they are encapsulated by a protective, self-produced extracellular matrix made from polymeric substances, they are mechanically robust and resistant to standard antibacterial measures. If not removed, they can cause infections, obstructions and other complications.
Intense, steady flows push away impurities
The new technology, which was co-developed by Cornel Dillinger, Pedro Amado and other members of Francesco Clavica and Daniel Ahmed’s research teams, takes advantage of recent advances in the fields of robotics and microfluidics. Its main feature is a coating made from microscopic hair-like structures known as cilia. Under the influence of an acoustic field, which is applied externally via a piezoelectric transducer, these cilia begin to move. This movement produces intense, steady fluid flows with velocities of up to 10 mm/s – enough to break apart encrusted deposits (made from calcium carbonate, for example) and flush away biofilms from the inner and outer surfaces of implanted urological devices.
All fouled up: Typical examples of crystals known as encrustations that develop on the surfaces of urinary stents and catheters. (Courtesy: Pedro Amado and Shaokai Zheng)
“This is a major advance compared to existing stents and catheters, which require regular replacements to avoid obstruction and infections,” Clavica says.
The technology is also an improvement on previous efforts to clear implants by mechanical means, Ahmed adds. “Our polymeric cilia in fact amplify the effects of ultrasound by allowing for an effect known as acoustic streaming at frequencies of 20 to 100 kHz,” he explains. “This frequency is lower than that possible with previous microresonator devices developed to work in a similar way that had to operate in the MHz-frequency range.”
The lower frequency achieves the desired therapeutic effects while prioritizing patient safety and minimizing the risk of tissue damage, he adds.
Wider applications
In creating their technology, the researchers were inspired by biological cilia, which are a natural feature of physiological systems such as the reproductive and respiratory tracts and the central nervous system. Future versions, they say, could apply the ultrasound probe directly to a patient’s skin, much as handheld probes of ultrasound scanners are currently used for imaging. “This technology has potential applications beyond urology, including fields like visceral surgery and veterinary medicine, where keeping implanted medical devices clean is also essential,” Clavica says.
The researchers now plan to test new coatings that would reduce contact reactions (such as inflammation) in the body. They will also explore ways of improving the device’s responsiveness to ultrasound – for example by depositing thin metal layers. “These modifications could not only improve acoustic streaming performance but could also provide additional antibacterial benefits,” Clavica tells Physics World.
In the longer term, the team hope to translate their technology into clinical applications. Initial tests that used a custom-built ultrasonic probe coupled to artificial tissue have already demonstrated promising results in generating cilia-induced acoustic streaming, Clavica notes. “In vivo animal studies will then be critical to validate safety and efficacy prior to clinical adoption,” he says.
Cyril Hilsum, a former president of the Institute of Physics (IOP), celebrated his 100th birthday last week at a special event held at the Royal Society of Chemistry.
Born on 17 May 1925, Hilsum completed a degree in physics at University College London in 1945. During his career he worked at the Services Electronics Research Laboratory and the Royal Radar Establishment and in 1983 was appointed chief scientist of GEC Hirst Research Centre, where he later became research director before retiring aged 70.
Hilsum helped develop commercial applications for the semiconductor gallium arsenide and is responsible for creating the UK’s first semiconductor laser as well as developments that led to modern liquid crystal display technologies.
Between 1988 and 1990 he was president of the IOP, which publishes Physics World, and in 1990 was appointed a Commander of the Order of the British Empire (CBE) for “services to the electrical and electronics industry”.
Hilsum was honoured by many prizes during his career including IOP awards such as the Max Born Prize in 1987, the Faraday Medal in 1988 as well as the Richard Glazebrook Medal and Prize in 1998. In 2007 he was awarded the Royal Society’s Royal Medal “for his many outstanding contributions and for continuing to use his prodigious talents on behalf of industry, government and academe to this day”.
Looking back: Hilsum examines photographs that form an exhibition charting his life. (Courtesy: Lindey Hilsum)
Despite now being a centenarian, Hilsum still works part-time as chief science officer for Infi-tex Ltd, which produces force sensors for use in textiles.
“My birthday event was an amazing opportunity for me to greet old colleagues and friends,” Hilsum told Physics World. “Many had not seen each other since they had worked together in the distant past. It gave me a rare opportunity to acknowledge the immense contributions they had made to my career.”
Hilsum says that while the IOP gives much support to applied physics, there is still a great need for physicists “to give critical contributions to the lives of society as a whole”.
“As scientists, we may welcome progress in the subject, but all can get pleasure in seeing the results in their home, on their iPhone, or especially in their hospital!” he adds.
Californian software startup PiLogic announced $4 million in seed funding May 22 to develop satellite diagnostics and other artificial intelligence tools tailored for space applications.
Although there is no exact comparison to any known bacterium on Earth, the space bacteria shares some key genetic similarities with a terrestrial cousin.
This is a bonus edition of Space Minds by SpaceNews. Our guest today is Devin Brande, Director, Commercial Operations, National Geospatial-Intelligence Agency.
ST. LOUIS — The National Geospatial-Intelligence Agency announced awards May 21 to Palantir Technologies, the University of Illinois and Ursa Space Systems at the GEOINT Symposium 2025. Through a $13.8 […]
Connexion
Science Magazine
Discover Mag
Physics World
